SAW BLADE: SUIT MBS 400TCT 405 X 3.2 x 30.0mm 100T

* This is a 6 degree triple chip negative rake 96 teeth saw blade which is suitable for extruded aluminium sections * It is important when cutting with this blade to have material clamped on each side of the blade * Ideal for manufacturers of aluminium joinery *

* For extruded aluminium sections * Gives fast clean precision cutting * Important when using this saw make sure material is well clamped on each side of blade * The saw is ideal for the manufacture of aluminium joinery where sections are 4mm to 20mm * Use lubrication for best results *

* For Steel Cutting only, Blade is a Series 490-355-080 it is a special type steel cutting Blade and must run @(RPM 1350) or at 25 metres per sec to maintain its edge, these blades should not spark very much and will not Burr the edges if kepted sharp and a good method for cutting in a production enviroment.