SPARE PARTS

* This is the cog type drive belt for the TP-920 lathe *

* This shaft holds the change gears on the outside of the headstock on the TP-920 lathe *

This gear fits onto the outside of the headstock and is interchangable *

* These are the change gears for the TP-920 lathe * The set comprises of six interchangable gears for feed speed changes * Teeth on the gears are as follows: #18 28T #19 36T #20 42T #21 45T #22 60T #23 80T *

* This is a shaft in the gearbox #

* This is a small gear for the gearbox on the TP-920 lathe *

* This is a bushing for the gearbox of the TP-920 lathe *

* This is the plunger shaft that fits into the gear change lever on the gearbox of the TP-920 lathe *

* This part is the spring loaded handle on the end of the gear change lever (spring not included) on gearbox of the TP-920 lathe *

* This slide block is mounted under the saddle to hold the saddle onto the bed slidway *

* This indexing micrometer pan is situated at the base of the top slide assembly for adjusting the angle of the topslide *

* This part is the micrometer collar which fits behind the top slide handwheel on the TP-920 lathe *

* This part is to suit the TP-920 series lathes *

* This is the end mounting bracket for the leadscrew on the TP-920 lathe *

* This is the bushing for the tailstock of the TP-920 lathe *

* This is the main off/on F/Reverse switch for this lathe *

* This part is to suit the TP-920 series lathes *

* Drive pulley for headstock - TP-920 lathe *

* Headstock gear 28 teeth to suit TP-920 lathe *