- Show All
- AUTO RECONDITIONING MACHINES
- AXLE STANDS
- BATTERY CHARGERS
- ENGINE STANDS
- GREASE & OILS
- HYDRAULIC BODY JACKS
- HYDRAULIC BOTTLE JACKS
- HYDRAULIC TOE JACKS
- HYDRAULIC TROLLEY JACKS
- HYD ENGINE CRANES
- HYD MOTORCYCLE LIFT
- HYD TRANSMISSION JACKS
- HYD SPRING COMPRESSOR
- HYD VEHICLE POSITIONING JACK
- GARAGE ESSENTIALS
- OIL DRAIN TANK
- PANEL BEATING EQUIPMENT
- WORKSHOP PRESSES
DS-12: #8 LOCK ASSEMBLY
Excl. GST: $21.00
Incl. GST: $24.15
Incl. GST: $24.15
BALL SUPPORT TABLE TO SUIT VT-300
Excl. GST: $0.00
Incl. GST: $0.00
Incl. GST: $0.00
SAW BLADE: TCT 450 X 96T ZTR 440
Excl. GST: $0.00
Incl. GST: $0.00
* For extruded aluminium sections
* Gives fast clean precision cutting
* Important when using this saw make sure material is well clamped on each side of blade
* The saw is ideal for the manufacture of aluminium joinery where sections are 4mm to 20mm
* Use lubrication for best results *
| Dimensions | 0.45 × 0.45 × 0.035 cm |
|---|
Related products
SAW BLADE: SUIT MBS 250 TCT 250 X 2.0 x 0.0mm 100T
SKU:
SBT101010
SAW BLADE: SUIT MBS 300 TCT 300 X 2.0 x 0.0mm 100T
SKU:
SBT101013
SAW BLADE: SUIT MBS 350 TCT 350 X 2.0 x 0.0mm 100T
SKU:
SBT101016
SAW BLADE: SUIT MBS 400TCT 405 X 3.2 x 30.0mm 120T
SKU:
SBT101020
SAW BLADE: TCT 400 X 120T POS ALI (FRIDA)
SKU:
SBT101025
SAW BLADE: TCT 400 X 30 X 96T (ASTRA)
SKU:
SBT101030
SAW BLADE: TCT 350 X 84T ZTR 440
SKU:
SBT101540
SAW BLADE: TCT 355 x 2.5 x 2.00 x 80T x 25.4 Hole STEEL CUT
SKU:
SBT101550
* For Steel Cutting only, Blade is a Series 490-355-080 it is a
special type steel cutting Blade and must run @(RPM 1350) or at 25 metres per sec to maintain its edge, these blades should not spark very much and will not Burr the edges if kepted sharp and a good method for cutting in a production enviroment.