SAW BLADE: TCT 400 X 120T POS ALI (FRIDA)

* For extruded aluminium sections * Gives fast clean precision cutting * Important when using this saw make sure material is well clamped on each side of blade * The saw is ideal for the manufacture of aluminium joinery where sections are 4mm to 20mm * Use lubrication for best results *

* For Steel Cutting only, Blade is a Series 490-355-080 it is a special type steel cutting Blade and must run @(RPM 1350) or at 25 metres per sec to maintain its edge, these blades should not spark very much and will not Burr the edges if kepted sharp and a good method for cutting in a production enviroment.