- Show All
- AUTO RECONDITIONING MACHINES
- AXLE STANDS
- BATTERY CHARGERS
- ENGINE STANDS
- GREASE & OILS
- HYDRAULIC BODY JACKS
- HYDRAULIC BOTTLE JACKS
- HYDRAULIC TOE JACKS
- HYDRAULIC TROLLEY JACKS
- HYD ENGINE CRANES
- HYD MOTORCYCLE LIFT
- HYD TRANSMISSION JACKS
- HYD SPRING COMPRESSOR
- HYD VEHICLE POSITIONING JACK
- GARAGE ESSENTIALS
- OIL DRAIN TANK
- PANEL BEATING EQUIPMENT
- WORKSHOP PRESSES
END MILL: 10.0MM HSS-Co5 4FT STD LENGTH (SEA)
Excl. GST: $33.00
Incl. GST: $37.95
Incl. GST: $37.95
END MILL: 12.0MM HSS-Co5 4FT STD LENGTH (SEA)
Excl. GST: $38.50
Incl. GST: $44.28
Incl. GST: $44.28
END MILL: 11.0MM HSS-Co5 4FT STD LENGTH (SEA)
Excl. GST: $35.00
Incl. GST: $40.25
* This End Mill is a Standard, General Purpose with 4 Flutes
* Single End, Square End Style
* Center Cutting Type
* Right Hand Cut HSS-Co5 (5% Carbide)
* Rhc 30 Deg, Rhh 30 Deg
* For Plunge Cutting
* Peripheral Milling
* Deep Slotting and Pocketing at Higher Feed and Speeds
| Weight | 0.05 kg |
|---|---|
| Dimensions | 0.1 × 0.03 × 0.03 cm |
In stock
Related products
END MILL: HSS 9.0MM STD THR/SHANK ETS GSE
SKU:
EM-700424
END MILL: HSS 11.0MM STD THR/SHANK GSE
SKU:
EM-700432
END MILL: HSS 15.0MM STD THR/SHANK GSE
SKU:
EM-700448
END MILL: HSS 18.0MM STD THR/SHANK GSE
SKU:
EM-700460
END MILL: HSS 19.0MM STD THR/SHANK GSE
SKU:
EM-700464
END MILL: HSS 24.0MM STD THR/SHANK GSE
SKU:
EM-700484
END MILL: 3.0MM HSS-Co8 4FLUTE LONG-SERIES T/SHANK (SOMTA)
SKU:
EM-74210200
* These threaded shank End Mill are Long series General Purpose, 4 Flutes, Single End, Square End Style, Center Cutting Type, Right Hand Cut, HSS-M42 (8% Cobalt) ,
* Bright Finish, Rhc 30 Deg, Rhh 30 Deg, For Plunge Cutting, Peripheral Milling and Deep Slotting and Pocketing at Higher Feed and Speeds *
END MILL: 6.0MM HSS-Co8 4FLUTE LONG-SERIES T/SHANK (SOMTA)
SKU:
EM-74210206
* These threaded shank End Mill are Long series General Purpose, 4 Flutes, Single End, Square End Style, Center Cutting Type, Right Hand Cut, HSS-M42 (8% Cobalt) ,
* Bright Finish, Rhc 30 Deg, Rhh 30 Deg, For Plunge Cutting, Peripheral Milling and Deep Slotting and Pocketing at Higher Feed and Speeds *