- Show All
- AUTO RECONDITIONING MACHINES
- AXLE STANDS
- BATTERY CHARGERS
- ENGINE STANDS
- GREASE & OILS
- HYDRAULIC BODY JACKS
- HYDRAULIC BOTTLE JACKS
- HYDRAULIC TOE JACKS
- HYDRAULIC TROLLEY JACKS
- HYD ENGINE CRANES
- HYD MOTORCYCLE LIFT
- HYD TRANSMISSION JACKS
- HYD SPRING COMPRESSOR
- HYD VEHICLE POSITIONING JACK
- GARAGE ESSENTIALS
- OIL DRAIN TANK
- PANEL BEATING EQUIPMENT
- WORKSHOP PRESSES
EDM: TR100 TAP REMOVER
$7,200.00
* Light small portable compct design
* High speed & high efficiency and low cost
* Simple operation easy remove broken taps
* Dielectric – using ordinary tap water as a machine dielectric liquid
* Using any brass bar as electrode
* Removal of taps will not damage the threads
* Auto feed 30deg both left and right depth setting selectable arcing timer Auto retract Alarm messages Depth arrival over-tempreture *
| Weight | 17 kg |
|---|---|
| Dimensions | 0.4 × 0.4 × 0.3 cm |
Related products
EDM: CNC DNC42+DN40 SUPERDRILL
SKU:
EDM100140
* The Joemars DNC42 is specially designed for drilling hard materials such as hardened steel aaloys & tungston carbide in ranges of 0.2mm-3.0 mm
* This CNC EDM drill is a production drilling machine controlled by a Heidenhain controller
*The newly developed sparking cercuits are special to the DNC42 EDM super drills to enhance machine speed excellent flushing lower wear & higher accuracy*
EDM: JM325D SUPER DRILL
SKU:
EDM100150
* The Joemars JM325D is specially designed for drilling hard materials such as hardened steel alloys and tungstan carbide in ranges of 0.2mm - 3.0mm
* The newly developed sparking cercuits are special to the JM325D & JM528D EDM Super Drills to enhance machining speed excellent flushing lower wear & higher accuracy *
EDM: JM528D SUPER DRILL
SKU:
EDM100160
* The Joemars JM528D is specialy designed for drilling hard materials such as hardened steel alloys and tungstan carbide in ranges of 0.2mm - 3.0mm
* The newly developed sparking cercuits are special to the JM235D &JM528D Super Drills to enhance machining speed excellent flushing lower wear & higher accuracy *
EDM: CNC DNC35 DRILLING
SKU:
EDM100200
* The Joemars CNC DNC35 Drilling EDM machine comes with arm type movable control panel design for operator comfort
* Stainless steel work table ensures stability
* Half submerged work table increases the performance of machining
* The Heidenhain TNC310 controller holds 100 sets of machining memories
* 6 Kinds of machining parameters
* Five kinds of alarm indicators
* RS-232-C/V.24 interface
* Plus many other fuctions *
EDM: CNC WT655 WIRE CUT
SKU:
EDM100240
EDM: CNC JMNC2010+HD50
SKU:
EDM100280
EDM: JM430+AZ50R+D430
SKU:
EDM100330
EDM: JM500+NZ50+D500
SKU:
EDM100340