- Show All
- AUTO RECONDITIONING MACHINES
- AXLE STANDS
- BATTERY CHARGERS
- ENGINE STANDS
- GREASE & OILS
- HYDRAULIC BODY JACKS
- HYDRAULIC BOTTLE JACKS
- HYDRAULIC TOE JACKS
- HYDRAULIC TROLLEY JACKS
- HYD ENGINE CRANES
- HYD MOTORCYCLE LIFT
- HYD TRANSMISSION JACKS
- HYD SPRING COMPRESSOR
- HYD VEHICLE POSITIONING JACK
- GARAGE ESSENTIALS
- OIL DRAIN TANK
- PANEL BEATING EQUIPMENT
- WORKSHOP PRESSES
CUTTER ADPTOR: MT2 TO SUIT ANNULAR CUTTERS 19-32MM
$98.00
* This MT2 holder is suitable for holding angular cutters in drill press
* Hardened and precision ground
* Holds 19mm (Weldon shank) cutters
* Has grub screws for retaining cutter
* Arbor has tanged end
| Weight | 0.6 kg |
|---|---|
| Dimensions | 0.18 × 0.04 × 0.04 cm |
In stock
Related products
CUTTER HOLDER: MT2 TO SUIT ANNULAR CUTTERS 19MM
SKU:
DS-7200515
CUTTER HOLDER: MT4 TO SUIT ANNULAR CUTTERS 19MM
SKU:
DS-7200540
CUTTER HOLDER: EUROBOOR MT4 x 31.75 WELDON SHANK
SKU:
DS-7200548
LOCATING PIN: 6.35mm X 125mm =L125mm -75mm
SKU:
DS-7200675
LOCATING PIN: 6.35mm X 102mm L=102mm
SKU:
DS-7200700
LOCATING PIN: 7.98mm X 77mm L=77mm
SKU:
DS-7200720
ANNULAR CUTTER: HSS 13MM X 25MM
SKU:
DS-7201213
* Dimac annular cutters are manufactured from HSS-M2 for durability and long service life
* These annular cutters have precision-ground flutes to provide efficient chip clearance
* This increasing drilling productivity and decreasing cutter breakage
* Manufactured of hardened high-speed tool steel, these cutters produce a burr-free finished hole without predrilling or stepdrilling
ANNULAR CUTTER: HSS 15MM X 25MM
SKU:
DS-7201215
* Dimac annular cutters are manufactured from HSS-M2 for durability and long service life
* These annular cutters have precision-ground flutes to provide efficient chip clearance
* This increasing drilling productivity and decreasing cutter breakage
* Manufactured of hardened high-speed tool steel, these cutters produce a burr-free finished hole without predrilling or stepdrilling